cvijo's dashboard

I have Extreme Networks' ethernet switch model SUMMIT X150-24t. It is managable switch. On that switch it is connected our device with EM1202+RJ1202 integrated in it. Everything works fine until I disable the port on the switch and then enable it back. After I disable the port link goes down and leds on the switch and EM1202 turns off, which is expected. But when I enable the port link doesn't go up and it stucks in down state until I manually reset EM1202. Same thing is happening if I reboot the switch (through the console) or if I turn the swithch off and than on again. Also same thing is happening regardless of port configuration (auto-negotiation off, speed 100 Mb/s, full duplex). Also same is happening with EM1000 module on your development board.

But I should notice that this is not happening with EM203 and EM200 modules. It is also not happenig with other switches (not managable ones) or when I connect EM1202 directly on PC and then disable and enable NIC. Also it is not happenig with other devices connected on switch (PC)

Every time when network administrator is playing around with switch and configures ports or power failure occurs on switch, EM1202 loses link. It is a big problem for us since equipement is already instaled at our customer and power failures do happen sometimes, also admin sometimes resets the switch (uprgading firmware for example).

If you have any idea what could be wrong please help us. I already played around with port configurations and tried everything. Although I'm not sure but I think it is probably something with EM1202. Best way would be if you could try it for yourself, maybe with some other managable switch.

Will it be possible to upgrade application written in basic through the network like with EM203 devices which use net loader for this. Maybe you could add some library function which could be added in application.